VMware vSphere 6.0
I might be light on details, but I don't quite know where to start. I'm a "SAN beginner", but have been handed a built system and expected to support it.
I have a NetApp SAN that presents it's LUNs to a VMware environment. I noticed an existing datastore only shows two paths when I check "Datastores", "Datastore Details":
However, a new LUN that was already configured on the SAN and that I just configured in NetApp to present to the same ESXi hosts is showing 8 paths:
I'm not quite sure where to start to figure out the difference. Both LUNs are being presented to the same number of hosts.
Where can I start to figure out if this is a "problem"?